Re: [CAD_CAM_EDM_DRO] Re: Stock gear drawing downloads???

Hi Gary,

I tried it before, but couldn't get any calcs out of it. I have a pair
of 80 tooth, 32mm PD, .4 module gears. I'm really only looking for the
ctr-ctr distance, which I suspect is 32 mm (1/2 pd + 1/2 pd).

I have other pairs of gears, 110 & 55, 40 & 120 which should be very
close to the same ctr-ctr distance (2:1 is off by a mm).

Application is a Micromouse design. I needed to fold up the drive to
fit in the required space, and also allow experimentation with the gear
ratio.

thanks,

Alan KM6VV

Gary Davison wrote:

>>I'm looking for a gear calc program that will give me center-center
>>spacing for METRIC gears (.4 module).
>>
>>Alan KM6VV
>>
>
>
>
> Alan
>
> will this site work for you:
>
> http://wwweng.uwyo.edu/commend/Sgdc/
>
> Gary
>