CAD CAM EDM DRO - Yahoo Group Archive

Threads on a ball screw........

Posted by Jack
on 2010-02-23 08:05:22 UTC
I have converted my minimill to ball screws but was having problems with
shaft collars shifting causing backlash. The solution was to fit a nut
to lock the collar in place. I had trouble with both my lathe and the
hard material in turning the thread and spoiled the thread. The
solution was to turn down the shaft in that area. Drill out and cut off
a bolt to form a threaded sleeve. The sleeve is attached with sleeve
retaining goop. Assuming the goop holds the sleeve this is a simple
way to put threads on the ball screw and I plan on using the method in
the future since it was quick and simple. I thought this might be of
use to someone in the group.

Jack

Discussion Thread

Jack 2010-02-23 08:05:22 UTC Threads on a ball screw........ David G. LeVine 2010-02-23 11:27:11 UTC Re: [CAD_CAM_EDM_DRO] Threads on a ball screw........ Jack McKie 2010-02-23 13:00:16 UTC Re: [CAD_CAM_EDM_DRO] Threads on a ball screw........ Will Holding 2010-02-25 11:31:33 UTC Re: [CAD_CAM_EDM_DRO] Threads on a ball screw........ Jack McKie 2010-02-25 13:27:33 UTC Re: [CAD_CAM_EDM_DRO] Threads on a ball screw........ Steve Blackmore 2010-02-25 14:00:08 UTC Re: [CAD_CAM_EDM_DRO] Threads on a ball screw........ david@f... 2010-02-25 15:30:54 UTC Re: [CAD_CAM_EDM_DRO] Threads on a ball screw........ Roland Jollivet 2010-02-26 08:24:03 UTC Re: [CAD_CAM_EDM_DRO] Threads on a ball screw........ leswatts@w... 2010-02-26 08:52:51 UTC RE: [CAD_CAM_EDM_DRO] Threads on a ball screw........ Dan Mauch 2010-02-26 08:53:33 UTC Re: [CAD_CAM_EDM_DRO] Threads on a ball screw........ Will Holding 2010-02-26 13:30:42 UTC Re: [CAD_CAM_EDM_DRO] Threads on a ball screw........ Dave Halliday 2010-02-27 22:47:30 UTC Threads on a ball screw - annealing and tempering thereof...