Re: [CAD_CAM_EDM_DRO] aluminum Vee rails ?

On 05/18/2012 09:07 PM, turbulatordude wrote:

> I have seen the 80/20 extrusions that have the Vee rails as part of the extrusion.
>
> is using aluminum practical for this purpose ?
>
> Anyone know what the grade of aluminum might be ?
>
> Dave

Look at http://www.makerslide.com/ for details.

Dave 8{)

--
/"Political Correctness is a doctrine, fostered by a delusional,
illogical minority and rabidly promoted by an unscrupulous mainstream
media, which holds forth the proposition that it is entirely possible to
pick up a turd by the clean end."/
(quoted from http://www.wattflyer.com/forums/showthread.php?t=30060)

NOTE TO ALL:


When forwarding emails, please use only "Blind Carbon Copy" or "Bcc" for
all recipients. Please "delete" or "highlight & cut" any forwarding
history which includes my email address! It is a courtesy to me and
others who may not wish to have their email addresses sent all over the
world! Erasing the history helps prevent Spammers from mining addresses
and viruses from being propagated.

THANK YOU!


[Non-text portions of this message have been removed]