Re: [CAD_CAM_EDM_DRO] Stepper motors

Peter,

Thanks for the ideas. I looked at the new shaftloc and it is what I am
looking for.

We are lucky to have this list. I do not know what I would do without the
internet.

Bob Campbell

----- Original Message -----
From: <ptengin@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Friday, August 18, 2000 9:29 PM
Subject: Re: [CAD_CAM_EDM_DRO] Stepper motors


> In a message dated 08/18/2000 3:07:28 PM Hawaiian Standard Time,
> bob@... writes:
>
> << I wish they had larger set screws.
> They seem to work fine. The only problem that I had was with vibrations
> causing the set screws to come loose. I put them back with some blue
> loc-tite. >>
>
> Gents,
>
> Set screws are a no no on stepper systems. If you are to get any kind
of
> reliability, you should use split clamp or wedge lock systems. QD taper
lock
> type pulleys but in smaller bores are available. I think Stock Drive
Products
> calls their version Fairloc.
>
> Peter
> THRD, Inc.
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager