Re: [CAD_CAM_EDM_DRO] Stepper motors

In a message dated 08/18/2000 3:07:28 PM Hawaiian Standard Time,
bob@... writes:

<< I wish they had larger set screws.
They seem to work fine. The only problem that I had was with vibrations
causing the set screws to come loose. I put them back with some blue
loc-tite. >>

Gents,

Set screws are a no no on stepper systems. If you are to get any kind of
reliability, you should use split clamp or wedge lock systems. QD taper lock
type pulleys but in smaller bores are available. I think Stock Drive Products
calls their version Fairloc.

Peter
THRD, Inc.