CAD CAM EDM DRO - Yahoo Group Archive

Re: stepper motors

Posted by Bob Bachman
on 1999-07-01 11:21:39 UTC
A question on diassembling stepper motors. I seem to recall reading
warnings of
bad things happening to stepper motors if they are taken apart. Any thoughts
on this or is my less than reliable memory faulty again?

Bob

>I has disassembled both types of Superior Electric motors and found very
>little to no differences. Remember, a coil wound for 24 volts DC and
>one wound for 120 volts AC are almost the same.
>
>Just unsolder the connector plate and remove it, and you will see coils
>that look identical for both types.
>
>John Grant

Discussion Thread

TADGUNINC@x... 1999-06-30 21:33:35 UTC Re: stepper motors TADGUNINC@x... 1999-06-30 21:37:59 UTC Re: stepper motors Jon Elson 1999-06-30 23:38:36 UTC Re: stepper motors Jon Elson 1999-06-30 23:41:15 UTC Re: stepper motors Dan Mauch 1999-07-01 06:57:01 UTC Re: stepper motors John Grant 1999-07-01 08:53:30 UTC Re: stepper motors Ted 1999-07-01 08:10:46 UTC Re: stepper motors Bob Bachman 1999-07-01 11:21:39 UTC Re: stepper motors Robert N Ash 1999-07-01 09:20:08 UTC Re: stepper motors TADGUNINC@x... 1999-07-01 08:42:37 UTC Re: stepper motors TADGUNINC@x... 1999-07-01 08:44:35 UTC Re: stepper motors John Grant 1999-07-01 09:50:46 UTC Re: stepper motors John Grant 1999-07-01 10:11:25 UTC Re: stepper motors John Grant 1999-07-01 10:17:02 UTC Re: stepper motors bobd@m... 1999-07-02 02:33:22 UTC Re: stepper motors Dan Mauch 1999-07-02 06:20:05 UTC Re: stepper motors John Grant 1999-07-02 08:38:01 UTC Re: stepper motors bobd@m... 1999-07-03 06:19:53 UTC Re: stepper motors John Grant 1999-07-03 10:05:00 UTC Re: stepper motors Eugene McCully 2001-11-20 23:02:08 UTC stepper motors shymu@b... 2001-11-21 04:38:13 UTC Re: stepper motors Robert Campbell 2004-02-08 16:14:04 UTC stepper motors Bob McKnight 2004-02-08 16:15:54 UTC Re: [CAD_CAM_EDM_DRO] stepper motors Donald K. Duncan 2004-02-08 17:09:46 UTC Re: [CAD_CAM_EDM_DRO] stepper motors Bob McKnight 2004-02-08 17:24:36 UTC Re: [CAD_CAM_EDM_DRO] stepper motors