CAD CAM EDM DRO - Yahoo Group Archive

Re: stepper motors

Posted by bobd@m...
on 1999-07-02 02:33:22 UTC
There is a danger disassembling stepper motors!

The ones with permanent magnets in the rotor are magnetised in situ within
the stator or in a 'keeper' and transferred into the stator during
manufacture. If you remove the rotor from the stator and then return it you
will find that the motor is less powerful than it was. I did this very
thing. I extended the rear shaft for a handwheel and that particular motor
is now weak. Does anyone know how to remagetise it?

Bob

At 09:17 1/07/99 -0800, you wrote:
>From: John Grant <grantjoh@...>
>
>Bob Bachman wrote:
>
>> A question on diassembling stepper motors. I seem to recall reading
>> warnings of
>> bad things happening to stepper motors if they are taken apart. Any
thoughts
>> on this or is my less than reliable memory faulty again?
>
>Your memory is fine, BUT you have to look carefully at the details on
>this warning from Superior Electric.
>
>They are talking about talking the *rotor* apart. I do not know why
>anyone would want to do this, but I can understand that it would not be
>good for the motor.
>
>John Grant
>

Discussion Thread

TADGUNINC@x... 1999-06-30 21:33:35 UTC Re: stepper motors TADGUNINC@x... 1999-06-30 21:37:59 UTC Re: stepper motors Jon Elson 1999-06-30 23:38:36 UTC Re: stepper motors Jon Elson 1999-06-30 23:41:15 UTC Re: stepper motors Dan Mauch 1999-07-01 06:57:01 UTC Re: stepper motors John Grant 1999-07-01 08:53:30 UTC Re: stepper motors Ted 1999-07-01 08:10:46 UTC Re: stepper motors Bob Bachman 1999-07-01 11:21:39 UTC Re: stepper motors Robert N Ash 1999-07-01 09:20:08 UTC Re: stepper motors TADGUNINC@x... 1999-07-01 08:42:37 UTC Re: stepper motors TADGUNINC@x... 1999-07-01 08:44:35 UTC Re: stepper motors John Grant 1999-07-01 09:50:46 UTC Re: stepper motors John Grant 1999-07-01 10:11:25 UTC Re: stepper motors John Grant 1999-07-01 10:17:02 UTC Re: stepper motors bobd@m... 1999-07-02 02:33:22 UTC Re: stepper motors Dan Mauch 1999-07-02 06:20:05 UTC Re: stepper motors John Grant 1999-07-02 08:38:01 UTC Re: stepper motors bobd@m... 1999-07-03 06:19:53 UTC Re: stepper motors John Grant 1999-07-03 10:05:00 UTC Re: stepper motors Eugene McCully 2001-11-20 23:02:08 UTC stepper motors shymu@b... 2001-11-21 04:38:13 UTC Re: stepper motors Robert Campbell 2004-02-08 16:14:04 UTC stepper motors Bob McKnight 2004-02-08 16:15:54 UTC Re: [CAD_CAM_EDM_DRO] stepper motors Donald K. Duncan 2004-02-08 17:09:46 UTC Re: [CAD_CAM_EDM_DRO] stepper motors Bob McKnight 2004-02-08 17:24:36 UTC Re: [CAD_CAM_EDM_DRO] stepper motors