Re: Stepper motor from Sherline?
Posted by
Randy Gordon-Gilmore
on 2000-11-01 15:05:16 UTC
At 03:48 PM 11/1/00 -0700, Tim wrote:
above the 2 amp listing. :-) You're right, there is no reason not to get
that one.
Best regards,
Randy
Randy Gordon-Gilmore ,----.___________ ______________ _________________
ProtoTrains // = = === == || == == == = || == == == = == =|
Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
zephyrus@... http://www.rickadee.net/~zephyrus
>Buy the 5 amp unit. It doesn't cost a lot more and you will be all set whenDoh, I didn't even see that one... It's clever, the way Dan hid it right
above the 2 amp listing. :-) You're right, there is no reason not to get
that one.
Best regards,
Randy
Randy Gordon-Gilmore ,----.___________ ______________ _________________
ProtoTrains // = = === == || == == == = || == == == = == =|
Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
zephyrus@... http://www.rickadee.net/~zephyrus
Discussion Thread
Randy Gordon-Gilmore
2000-11-01 11:18:01 UTC
Stepper motor from Sherline?
Tim Goldstein
2000-11-01 11:57:44 UTC
RE: [CAD_CAM_EDM_DRO] Stepper motor from Sherline?
Alan Marconett KM6VV
2000-11-01 12:04:13 UTC
Re: [CAD_CAM_EDM_DRO] Stepper motor from Sherline?
Randy Gordon-Gilmore
2000-11-01 14:02:05 UTC
Re: Stepper motor from Sherline?
Tim Goldstein
2000-11-01 14:44:17 UTC
RE: [CAD_CAM_EDM_DRO] Re: Stepper motor from Sherline?
Randy Gordon-Gilmore
2000-11-01 15:05:16 UTC
Re: Stepper motor from Sherline?
ballendo@y...
2000-11-01 15:32:18 UTC
Re: Stepper motor from Sherline?
Dan Mauch
2000-11-01 15:43:58 UTC
Re: [CAD_CAM_EDM_DRO] Re: Stepper motor from Sherline?
Randy Gordon-Gilmore
2000-11-01 15:57:30 UTC
Re: Stepper motor from Sherline?
Randy Gordon-Gilmore
2000-11-01 16:06:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: Stepper motor from Sherline?
Alan Marconett KM6VV
2000-11-01 16:30:18 UTC
Re: Stepper motor from Sherline?
Randy Gordon-Gilmore
2000-11-01 17:19:42 UTC
Re: Stepper motor from Sherline?
Dan Mauch
2000-11-02 06:35:42 UTC
Re: [CAD_CAM_EDM_DRO] Re: Stepper motor from Sherline?