Re: [CAD_CAM_EDM_DRO] Re: Stepper motor from Sherline?

Correct
Dan
-----Original Message-----
From: Randy Gordon-Gilmore <zephyrus@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Wednesday, November 01, 2000 3:57 PM
Subject: [CAD_CAM_EDM_DRO] Re: Stepper motor from Sherline?

>At 03:43 PM 11/1/00 -0800, Dan wrote:
>
>>hot. I have run the 2A drivers up to 38VDC. But I used a separate 5vdc
>>supply for the logic. You could also use a large but inefficient dropping
>
>Thanks for the reply, Dan. I do have a couple of little 5V regulated
>supplies. Would that just involve leaving out the 5V regulator and running
>the output of the 5V supply to the vacated output pad?
>
>Best regards,
>
>Randy
>
>Randy Gordon-Gilmore ,----.___________ ______________ _________________
>ProtoTrains // = = === == || == == == = || == == == = == =|
>Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
>zephyrus@... http://www.rickadee.net/~zephyrus
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>