RE: Servo Motors

Bill,

Try http://www.isomedia.com/homes/billmw/
This site advocated servos and features the type of system that Dan at
Camtronics sells (meaning that the error correction is handled by
electronics outside of the control program)

http://www.mmsonline.com/articles/049703.html will give you an article about
encoders

http://www.mmsonline.com/articles/039701.html is an article about motion
control cards


Tim
[Denver, CO]

> -----Original Message-----
> From: William Scalione [mailto:scalione@...]
> Sent: Tuesday, July 13, 1999 8:55 PM
>
> From: William Scalione <scalione@...>
>
> Hi,
>
> Does anybody know of a website that gives a good description
> of the inner workings of servo motors, encoders, and the drivers
> needed to run them? I have the stepper stuff down pretty good but
> servo motors are a whole new ballgame.I just bought a CNC lathe
> with bad electronics on board, and will need to convert it using
> Dan Mauch's driver board or a Servo To Go card. Would like to
> read up on it before spending all my money. This CNC stuff
> sure gets expensive dosen't it?
>
> Thanks
> Bill Scalione