Re: [CAD_CAM_EDM_DRO]A question of size managenent.

--- In CAD_CAM_EDM_DRO@egroups.com, BillDarby <ddarby@s...> wrote:

Here's the equivalent in arc language from backplotting the code you
posted & performing an Arc Spline, it starts at the last Z move
(from Vector):

N10 G00 X246.9320 Y78.0410 Z35.8920
N11 G01 X247.4303 Y78.0283
N12 G02 X256.7913 Y77.2217 I-1.9890 J-77.8060
N13 X265.9980 Y75.2915 I-11.3817 J-77.2139
N14 G01 X266.4680 Y75.1630

Here's your code:

> Line X 246.9320 Y 78.0410 Z 35.8920
> Line X 248.4550 Y 77.9960
> Line X 249.9760 Y 77.9220
> Line X 251.4950 Y 77.8180
> Line X 253.0130 Y 77.6850
> Line X 254.5270 Y 77.5220
> Line X 256.0380 Y 77.3290
> Line X 257.5440 Y 77.1070
> Line X 259.0460 Y 76.8560
> Line X 260.5430 Y 76.5760
> Line X 262.0350 Y 76.2660
> Line X 263.5190 Y 75.9270
> Line X 264.9970 Y 75.5590
> Line X 266.4680 Y 75.1630
>

This was back plotted by removing spaces & the "Line" words with
Replace, and adding a G01 on the first line. Then applied the Arc-
Spline and Generated NC.

Best Regards,

Fred Smith
IMService