Re: [CAD_CAM_EDM_DRO] interpolation and algorithms of multiple axes was Re: Pulse Gen

Yes I will need the Gerber's with an aperture file if possible ( if not
embedded) as well as the excellon drill file and tool list.
Dan
-----Original Message-----
From: Mariss Freimanis <geckohall@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Thursday, December 07, 2000 7:54 AM
Subject: [CAD_CAM_EDM_DRO] interpolation and algorithms of multiple axes was
Re: Pulse Gen

>Hi,
>
>Dan, the first board layout will be surface mount. Afterwards when
>time allows I can do a DIP thru-hole layout. I assume you would need
>gerber files.
>
>I will be posting the circuit diagram so you or anyone else can do
>their own board layouts as well.
>
>There will no limit on the number of axies possible. Each axis' data
>input will be an 8-bit wide, 2-bit deep shift register. The output of
>the SR goes to the data input of the next pulse gen card. This means
>the axies cascade. The SR depth will increase by 2 bits for every
>card added.
>
>As an example, a 6-axis setup will an 8-bit wide, 12-bit deep shift
>register. The LPT would output a 12-byte burst on every interrupt.
>
>Mariss
>
>
>
>--- In CAD_CAM_EDM_DRO@egroups.com, "Dan Mauch" <dmauch@s...> wrote:
>> Could you also provide artwork for a through hole version PCB ?. If
>you do
>> then I would volunteer to have some boards made and low cost kits
>made
>> available to those that wanted one but can't handle surface mount
>or want to
>> search for parts.
>
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>