CAD CAM EDM DRO - Yahoo Group Archive

re:Re: Re: not stiff enough!

Posted by ballendo@y...

on 2001-01-19 15:26:54 UTC

Joe V wrote:

>A 1/16" router bit generates negligible side load. This is about
>the size that people are using with much less rigid setups than
>yours. It sounds like you have either slop in your bearings or
>backlash.

Joe,

Nice post! Good points!

Ballendo

Discussion Thread

Richard Spelling 2001-01-19 07:52:25 UTC not stiff enough! Joe Vicars 2001-01-19 09:48:54 UTC Re: [CAD_CAM_EDM_DRO] not stiff enough! John D. Guenther 2001-01-19 09:50:39 UTC Re: not stiff enough! richard@s... 2001-01-19 12:13:42 UTC Re: not stiff enough! richard@s... 2001-01-19 12:28:42 UTC Re: not stiff enough! Smoke 2001-01-19 12:31:32 UTC Re: [CAD_CAM_EDM_DRO] Re: not stiff enough! Joe Vicars 2001-01-19 12:32:18 UTC Re: [CAD_CAM_EDM_DRO] Re: not stiff enough! richard@s... 2001-01-19 12:45:53 UTC Re: not stiff enough! ballendo@y... 2001-01-19 15:03:42 UTC Re: not stiff enough! ballendo@y... 2001-01-19 15:23:02 UTC re:Re: not stiff enough! ballendo@y... 2001-01-19 15:26:54 UTC re:Re: Re: not stiff enough! Terry Ackland 2001-01-19 17:06:48 UTC re:Re: Re: not stiff enough! Les Watts 2001-01-20 05:48:47 UTC Re: [CAD_CAM_EDM_DRO] not stiff enough! Smoke 2001-01-20 11:50:07 UTC Re: [CAD_CAM_EDM_DRO] not stiff enough! Les Watts 2001-01-20 14:44:28 UTC Re: [CAD_CAM_EDM_DRO] not stiff enough! Smoke 2001-01-20 15:20:55 UTC Re: [CAD_CAM_EDM_DRO] not stiff enough! Richard Spelling 2001-01-22 07:00:24 UTC Re: not stiff enough! Steve Greenfield 2001-01-22 08:41:48 UTC Re: not stiff enough!