re:Re: Re: not stiff enough!
Posted by
Terry Ackland
on 2001-01-19 17:06:48 UTC
--- if you feed at a rate faster than the chips can be cleared you
will end up with a mess. CNC does not mean you you can work at a
million miles per hour, speeds and feeds for the material being cut
must be respected.
Watch Norm Abrams and the speed he guides his router at on PBS tv. He
is my wife's dream boy, makes beautiful furniture in half an hour with
no mess!
T. Ackland
In CAD_CAM_EDM_DRO@egroups.com, ballendo@y... wrote:
will end up with a mess. CNC does not mean you you can work at a
million miles per hour, speeds and feeds for the material being cut
must be respected.
Watch Norm Abrams and the speed he guides his router at on PBS tv. He
is my wife's dream boy, makes beautiful furniture in half an hour with
no mess!
T. Ackland
In CAD_CAM_EDM_DRO@egroups.com, ballendo@y... wrote:
> Joe V wrote:
> >A 1/16" router bit generates negligible side load. This is about
> >the size that people are using with much less rigid setups than
> >yours. It sounds like you have either slop in your bearings or
> >backlash.
>
> Joe,
>
> Nice post! Good points!
>
> Ballendo
Discussion Thread
Richard Spelling
2001-01-19 07:52:25 UTC
not stiff enough!
Joe Vicars
2001-01-19 09:48:54 UTC
Re: [CAD_CAM_EDM_DRO] not stiff enough!
John D. Guenther
2001-01-19 09:50:39 UTC
Re: not stiff enough!
richard@s...
2001-01-19 12:13:42 UTC
Re: not stiff enough!
richard@s...
2001-01-19 12:28:42 UTC
Re: not stiff enough!
Smoke
2001-01-19 12:31:32 UTC
Re: [CAD_CAM_EDM_DRO] Re: not stiff enough!
Joe Vicars
2001-01-19 12:32:18 UTC
Re: [CAD_CAM_EDM_DRO] Re: not stiff enough!
richard@s...
2001-01-19 12:45:53 UTC
Re: not stiff enough!
ballendo@y...
2001-01-19 15:03:42 UTC
Re: not stiff enough!
ballendo@y...
2001-01-19 15:23:02 UTC
re:Re: not stiff enough!
ballendo@y...
2001-01-19 15:26:54 UTC
re:Re: Re: not stiff enough!
Terry Ackland
2001-01-19 17:06:48 UTC
re:Re: Re: not stiff enough!
Les Watts
2001-01-20 05:48:47 UTC
Re: [CAD_CAM_EDM_DRO] not stiff enough!
Smoke
2001-01-20 11:50:07 UTC
Re: [CAD_CAM_EDM_DRO] not stiff enough!
Les Watts
2001-01-20 14:44:28 UTC
Re: [CAD_CAM_EDM_DRO] not stiff enough!
Smoke
2001-01-20 15:20:55 UTC
Re: [CAD_CAM_EDM_DRO] not stiff enough!
Richard Spelling
2001-01-22 07:00:24 UTC
Re: not stiff enough!
Steve Greenfield
2001-01-22 08:41:48 UTC
Re: not stiff enough!