CAD CAM EDM DRO - Yahoo Group Archive

Re: not stiff enough!

on 2001-01-22 08:41:48 UTC
And on behalf of -all- newbies, thank you for asking. I know I learned
a lot.

I even have some 3/4 inch stainless rod, two of them about 4ft long.
Look like they are ground, not rolled, and I got them out of a trash
heap! It sounds like they'll be more than stiff enough using the tips
I've learned here.

Steve Greenfield

"Richard Spelling" <richard@s...> wrote:
> Thanks all those who responded to my stiffness quiestions.
-snip-
> Thanks again. I'll probably not rebuild the machine from scratch,
though
> Mark III will be a stiffer design all around.

Discussion Thread

Richard Spelling 2001-01-19 07:52:25 UTC not stiff enough! Joe Vicars 2001-01-19 09:48:54 UTC Re: [CAD_CAM_EDM_DRO] not stiff enough! John D. Guenther 2001-01-19 09:50:39 UTC Re: not stiff enough! richard@s... 2001-01-19 12:13:42 UTC Re: not stiff enough! richard@s... 2001-01-19 12:28:42 UTC Re: not stiff enough! Smoke 2001-01-19 12:31:32 UTC Re: [CAD_CAM_EDM_DRO] Re: not stiff enough! Joe Vicars 2001-01-19 12:32:18 UTC Re: [CAD_CAM_EDM_DRO] Re: not stiff enough! richard@s... 2001-01-19 12:45:53 UTC Re: not stiff enough! ballendo@y... 2001-01-19 15:03:42 UTC Re: not stiff enough! ballendo@y... 2001-01-19 15:23:02 UTC re:Re: not stiff enough! ballendo@y... 2001-01-19 15:26:54 UTC re:Re: Re: not stiff enough! Terry Ackland 2001-01-19 17:06:48 UTC re:Re: Re: not stiff enough! Les Watts 2001-01-20 05:48:47 UTC Re: [CAD_CAM_EDM_DRO] not stiff enough! Smoke 2001-01-20 11:50:07 UTC Re: [CAD_CAM_EDM_DRO] not stiff enough! Les Watts 2001-01-20 14:44:28 UTC Re: [CAD_CAM_EDM_DRO] not stiff enough! Smoke 2001-01-20 15:20:55 UTC Re: [CAD_CAM_EDM_DRO] not stiff enough! Richard Spelling 2001-01-22 07:00:24 UTC Re: not stiff enough! Steve Greenfield 2001-01-22 08:41:48 UTC Re: not stiff enough!