Re: not stiff enough!
Posted by
Richard Spelling
on 2001-01-22 07:00:24 UTC
Thanks all those who responded to my stiffness quiestions.
Taking cuts no more than 1/2" the bit diameter, and running the routine
twice has solved 90% of the problems. Ran some test holes, and determined if
I set the bit size right, run the program twice, and take light cuts, I can
cut a hole damn close to exactly the size I want.
Still get some flex when the 1/4" router bit plunges in. I'm putting the
3/4" rails on Z, and trying different bits.
Thanks again. I'll probably not rebuild the machine from scratch, though
Mark III will be a stiffer design all around.
Richard Spelling, http://www.spellingbusiness.com/boats
From the muddy waters of Oklahoma
Taking cuts no more than 1/2" the bit diameter, and running the routine
twice has solved 90% of the problems. Ran some test holes, and determined if
I set the bit size right, run the program twice, and take light cuts, I can
cut a hole damn close to exactly the size I want.
Still get some flex when the 1/4" router bit plunges in. I'm putting the
3/4" rails on Z, and trying different bits.
Thanks again. I'll probably not rebuild the machine from scratch, though
Mark III will be a stiffer design all around.
Richard Spelling, http://www.spellingbusiness.com/boats
From the muddy waters of Oklahoma
Discussion Thread
Richard Spelling
2001-01-19 07:52:25 UTC
not stiff enough!
Joe Vicars
2001-01-19 09:48:54 UTC
Re: [CAD_CAM_EDM_DRO] not stiff enough!
John D. Guenther
2001-01-19 09:50:39 UTC
Re: not stiff enough!
richard@s...
2001-01-19 12:13:42 UTC
Re: not stiff enough!
richard@s...
2001-01-19 12:28:42 UTC
Re: not stiff enough!
Smoke
2001-01-19 12:31:32 UTC
Re: [CAD_CAM_EDM_DRO] Re: not stiff enough!
Joe Vicars
2001-01-19 12:32:18 UTC
Re: [CAD_CAM_EDM_DRO] Re: not stiff enough!
richard@s...
2001-01-19 12:45:53 UTC
Re: not stiff enough!
ballendo@y...
2001-01-19 15:03:42 UTC
Re: not stiff enough!
ballendo@y...
2001-01-19 15:23:02 UTC
re:Re: not stiff enough!
ballendo@y...
2001-01-19 15:26:54 UTC
re:Re: Re: not stiff enough!
Terry Ackland
2001-01-19 17:06:48 UTC
re:Re: Re: not stiff enough!
Les Watts
2001-01-20 05:48:47 UTC
Re: [CAD_CAM_EDM_DRO] not stiff enough!
Smoke
2001-01-20 11:50:07 UTC
Re: [CAD_CAM_EDM_DRO] not stiff enough!
Les Watts
2001-01-20 14:44:28 UTC
Re: [CAD_CAM_EDM_DRO] not stiff enough!
Smoke
2001-01-20 15:20:55 UTC
Re: [CAD_CAM_EDM_DRO] not stiff enough!
Richard Spelling
2001-01-22 07:00:24 UTC
Re: not stiff enough!
Steve Greenfield
2001-01-22 08:41:48 UTC
Re: not stiff enough!