Re: [CAD_CAM_EDM_DRO] Diamond engraving cutters

The dremel cutters are for a reciprocating, vibrating engraving tool not a
rotary one. Thevdiamond drill points are for a rotary tool like a dentist
drill.
Jesse

----------

>From: "Rich D." <cmsteam@...>
>To: CAD_CAM_EDM_DRO@yahoogroups.com
>Subject: Re: [CAD_CAM_EDM_DRO] Diamond engraving cutters
>Date: Fri, Feb 2, 2001, 12:07 PM
>

> Alan,
> I've lost track of this thread. Are you the one doing the CNC glass
> engraving using the Dremel bits below?
> These are for a vibrating Dremel engraving tool.
> Are you using them in a rotating spindle?
> Rich D.
>
> Alan Marconett KM6VV wrote:
>>
>> Hi Marcus,
>>
>> Nope, not a diamond dresser. It's a 1/8" shaft cutter for a dremel
>> drill. 1" long, part #9929. I think I'll check dremel website (?), and
>> see if there's any information on it. I'd wager it's for engraving
>> little name plates or something. I've never used one! The carbide
>> "engraving point" is #9924.
>>
>> Alan KM6VV
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
> discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>