Re: [CAD_CAM_EDM_DRO] Diamond engraving cutters

Hi Rich,

That explains it! I bought the two bits from a MSC flyer, they were
across the page from two "Bedside readers", which I also ordered. They
didn't say what the bits were used for, but I was thinking of Robert's
work on glass. I just couldn't figure out what spinning the bit would
accomplish! I did not think of the bit being used in a "hand engraver",
just thought it was made for the Dremel tool. I haven't done ANY
engraving yet! Soon.

Alan KM6VV

"Rich D." wrote:

>
> Alan,
> I've lost track of this thread. Are you the one doing the CNC glass
> engraving using the Dremel bits below?
> These are for a vibrating Dremel engraving tool.
> Are you using them in a rotating spindle?
> Rich D.
>
> Alan Marconett KM6VV wrote:
> >
> > Hi Marcus,
> >
> > Nope, not a diamond dresser. It's a 1/8" shaft cutter for a dremel
> > drill. 1" long, part #9929. I think I'll check dremel website (?), and
> > see if there's any information on it. I'd wager it's for engraving
> > little name plates or something. I've never used one! The carbide
> > "engraving point" is #9924.
> >
> > Alan KM6VV