What to buy me, oh my

Marcus,

Thanks for the info. Hard to know where to shop! I did a job on a
brand new 3 in 1, simply turning a 1" steel shaft down to take a timing
belt pulley, and boring it through. Only about a foot long, but we
must've used most of a pint can of cutting fluid, and couldn't get a
good finish. I haven't heard if the owner is still happy with it, but
it sure made me think!

Alan KM6VV

Marcus & Eva wrote:

>
> Hi Alan:
> There's a picture of one in the April 1999 Machinist's Workshop magazine
> page 49.
> The model shown is a Jet JTM 830; the dealer in this particular ad is Alley
> Supply Company.
> Their phone number is (702) 782-3800.
> This machine, like all things Taiwanese, was marketed by a billion different
> companies, and has a vast range of quality depending on who handled it.
> Mine was made to order for a local Canadian company and was very good.
> Cheers

I'll try again,

>
> Marcus
>
> -----Original Message-----
> From: Alan Marconett KM6VV <KM6VV@...>
> To: CAD_CAM_EDM_DRO@yahoogroups.com <CAD_CAM_EDM_DRO@yahoogroups.com>
> Date: Thursday, February 22, 2001 11:57 AM
> Subject: [CAD_CAM_EDM_DRO] Re: What to buy me, oh my
>
> >Hi Marcus,
> >
> >That mill sounds like what I have been looking for. Do you recall a
> >model number? I had been thinking about the EMCO FB-2, but BlueRidge is
> >not importing them anymore! This sounds just a little bigger. Where is
> >it made?
> >
> >Tnx,
> >
> >Alan KM6VV