CAD CAM EDM DRO - Yahoo Group Archive

Re: Threadmill

Posted by Tony Jeffree
on 2001-03-08 01:17:03 UTC
At 23:58 07/03/2001 +0000, you wrote:
>I can't see any reason why you can't grind all the flutes off a tap
>except one to use a thread mill.

Sounds like that would work well - might give that a try. Of course, it
would only be good for internal threading if the thread diam being cut is
larger than the original tap diameter.

Regards,
Tony

Discussion Thread

John Stevenson 2001-03-06 18:36:41 UTC Threadmill Jon Anderson 2001-03-06 18:53:56 UTC Re: [CAD_CAM_EDM_DRO] Threadmill Alan Marconett KM6VV 2001-03-06 22:55:42 UTC Re: [CAD_CAM_EDM_DRO] Threadmill John Stevenson 2001-03-07 08:18:11 UTC Re: Threadmill John Stevenson 2001-03-07 08:28:01 UTC Re: Threadmill Jon Elson 2001-03-07 11:19:59 UTC Re: [CAD_CAM_EDM_DRO] Threadmill Alan Marconett KM6VV 2001-03-07 11:20:31 UTC Re: Threadmill Tony Jeffree 2001-03-08 01:17:03 UTC Re: Threadmill Alan Marconett KM6VV 2001-03-08 10:41:43 UTC Re: Threadmill Drew Rogge 2001-03-08 10:56:06 UTC Re: [CAD_CAM_EDM_DRO] Re: Threadmill Joe Vicars 2001-03-08 11:45:18 UTC Re: [CAD_CAM_EDM_DRO] Re: Threadmill Jon Anderson 2001-03-08 12:03:19 UTC Re: [CAD_CAM_EDM_DRO] Re: Threadmill dougrasmussen@c... 2001-03-08 12:42:58 UTC Re: Threadmill