CAD CAM EDM DRO - Yahoo Group Archive

+/- 10V Gecko

on 2001-03-21 16:06:04 UTC
Hi,

In responding to a previous post I neglected to mention what I'm
doing with the +/- 10V servo-amplifier. This will be the next drive
coming out (45 days or so) and will be called the G330. In short:

18 to 80 VDC supply
20A max motor current

Inputs: (jumper selected)
-------------------------
+/- 10 volt input
0 to 5 volt input
PWM input (5V logic compatible)

Operating modes: (jumper selected)
----------------------------------
Velocity mode (output voltage proportional to input)
Torque mode (output voltage proportional to input)
IR compensated (motor speed proportional to input)

Same size/price as G320.

If it needs something else besides the above, please let me know. The
board layout is nearly done and there is room left over. I can still
fill it with something useful, (4 to 20 mA current loop input?).

Mariss

Discussion Thread

mariss92705@y... 2001-03-21 16:06:04 UTC +/- 10V Gecko Matt Shaver 2001-03-21 17:28:51 UTC Re: [CAD_CAM_EDM_DRO] +/- 10V Gecko mariss92705@y... 2001-03-21 18:01:20 UTC Re: +/- 10V Gecko Jon Elson 2001-03-21 21:03:54 UTC Re: [CAD_CAM_EDM_DRO] +/- 10V Gecko Brian Pitt 2001-03-21 22:07:23 UTC Re: [CAD_CAM_EDM_DRO] Re: +/- 10V Gecko mariss92705@y... 2001-03-21 22:14:41 UTC Re: +/- 10V Gecko Tom Eldredge 2001-03-22 08:21:30 UTC Re: [CAD_CAM_EDM_DRO] Re: +/- 10V Gecko mariss92705@y... 2001-03-22 09:18:47 UTC Re: +/- 10V Gecko Jon Elson 2001-03-22 11:39:58 UTC Re: [CAD_CAM_EDM_DRO] Re: +/- 10V Gecko Jon Elson 2001-03-22 12:15:25 UTC Re: [CAD_CAM_EDM_DRO] Re: +/- 10V Gecko mariss92705@y... 2001-03-22 13:06:44 UTC Re: +/- 10V Gecko Jon Elson 2001-03-22 14:52:10 UTC Re: [CAD_CAM_EDM_DRO] Re: +/- 10V Gecko Ray 2001-03-22 19:51:27 UTC Re: Re: +/- 10V Gecko Jon Elson 2001-03-22 21:51:19 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: +/- 10V Gecko dave engvall 2001-03-22 22:40:25 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: +/- 10V Gecko