Re: [CAD_CAM_EDM_DRO] Re: deep pocket milling
Posted by
Bill Darby
on 2001-03-30 04:22:47 UTC
Hi
I was wondering if you thought it would be possible to get a
1/2" end mill long enough to support the outboard end and run
it as in a horizontal mill for this job (perhaps 8 inches of
flute) ? If you could find one, you could grind the tip to
accept a bearing/ bushing and I am sure it would do the job.
For a one of, not very practical though.
Bill Darby
I was wondering if you thought it would be possible to get a
1/2" end mill long enough to support the outboard end and run
it as in a horizontal mill for this job (perhaps 8 inches of
flute) ? If you could find one, you could grind the tip to
accept a bearing/ bushing and I am sure it would do the job.
For a one of, not very practical though.
Bill Darby
Discussion Thread
Victor Cantu Jr.
2001-03-24 10:24:02 UTC
deep pocket milling
Jon Anderson
2001-03-24 11:12:31 UTC
Re: [CAD_CAM_EDM_DRO] deep pocket milling
Rich D.
2001-03-24 13:01:54 UTC
Re: [CAD_CAM_EDM_DRO] deep pocket milling
Jon Elson
2001-03-24 20:28:38 UTC
Re: [CAD_CAM_EDM_DRO] deep pocket milling
Victor Cantu Jr.
2001-03-29 01:40:54 UTC
deep pocket milling
Marcus & Eva
2001-03-29 08:33:18 UTC
Re: [CAD_CAM_EDM_DRO] deep pocket milling
John Stevenson
2001-03-29 09:21:31 UTC
Re: deep pocket milling
Tony Jeffree
2001-03-29 14:15:52 UTC
Re: [CAD_CAM_EDM_DRO] deep pocket milling
John Stevenson
2001-03-29 14:31:12 UTC
Re: deep pocket milling
Spehro Pefhany
2001-03-29 14:45:58 UTC
Re: [CAD_CAM_EDM_DRO] Re: deep pocket milling
Marcus
2001-03-29 15:59:17 UTC
Re: [CAD_CAM_EDM_DRO] Re: deep pocket milling
Tony Jeffree
2001-03-29 22:26:14 UTC
Re: [CAD_CAM_EDM_DRO] deep pocket milling
Bill Darby
2001-03-30 04:22:47 UTC
Re: [CAD_CAM_EDM_DRO] Re: deep pocket milling
marble here
2001-03-30 05:54:07 UTC
Re: [CAD_CAM_EDM_DRO] Re: deep pocket milling
Marcus & Eva
2001-03-30 07:42:26 UTC
Re: [CAD_CAM_EDM_DRO] Re: deep pocket milling
Bill Darby
2001-04-01 11:12:34 UTC
Re: [CAD_CAM_EDM_DRO] Re: deep pocket milling