Re: [CAD_CAM_EDM_DRO] Re: deep pocket milling

I thought this is a pass thru hole if so .....


I agree with John on this one .We wire a lot at the
plant most of it is D2 or better die steel our Wire
can do up to 10" deep we make our own punchs for the
presses . To do a pass thru pocket like that one You
would have to drill a hole some where in the center
or close to the edge and feed the wire in set the
program and let it go may take more then few hours but
it will come out really good if a taper is needed ,it
would do it I think the one we have will do up to 10
deg's. cost wise wire may be the way to go



John

--- John Stevenson <machines@...> wrote:

> --- In CAD_CAM_EDM_DRO@e..., "Marcus & Eva"
> <implmex@a...> wrote:
> > Hi Vic:
> > Have you considered farming that pocket out to
> get wire EDM cut.
> > A 6 1/2" deep pocket with a 1/4" corner radius is
> going to be a
> pig's
>
>
> How do you wire a pocket?
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an
> unmoderated list for the discussion of shop built
> systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe:
> CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe:
> CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com,
> wanliker@...
> Moderator: jmelson@...
> timg@... [Moderator]
> URL to this page:
> http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to
> http://docs.yahoo.com/info/terms/
>
>

__________________________________________________
Do You Yahoo!?
Get email at your own domain with Yahoo! Mail.
http://personal.mail.yahoo.com/?.refer=text