Re: CNCpro VS Artisan VS flashcut

--- In CAD_CAM_EDM_DRO@y..., "Larry Edington" <ledington@c...> wrote:
> Yea, there are ways to network the DOS box. But it's just
> not worth the trouble to me. I lived
> through networking from Netware days to Windows days. I've
> run several DOS machines on
> a network. I shall NOT go back to those headaches ever
> again. So sneakernet is the easiest
> and most trouble free solution until all my Cnc controls are
> Windows based.
>
> later,
> Larry E.
>
> ----- Original Message -----
> From: <cla@m...>
> To: <CAD_CAM_EDM_DRO@y...>
> Sent: Tuesday, April 03, 2001 3:23 PM
> Subject: Re: [CAD_CAM_EDM_DRO] CNCpro VS Artisan VS flashcut
>
>
> > > sneaker net since I have to use floppies
> > > with the DOS based machines.
> >
> > This might be of some help to you. If you FTP to
> Microsoft you should be
> > able to find a freely available DOS Microsoft Network
> program. I don't
> > remember what it is called exactly and it was a few years
> back that I got
> > it. But it will allow you to network to your DOS machines.
> I used on one of
> > my machines some time back. If fact, if you can't locate
> it I may be able
> > to find it and email it to you.
> >
> > Claton Cadmus
> >
> >
> > Welcome to CAD_CAM_EDM_DRO@e...,an unmoderated list
> for the discussion of shop built systems, for CAD, CAM, EDM,
> and DRO.
> >
> > Addresses:
> > Post message: CAD_CAM_EDM_DRO@y...
> > Subscribe: CAD_CAM_EDM_DRO-subscribe@y...
> > Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@y...
> > List owner: CAD_CAM_EDM_DRO-owner@y...,
> wanliker@a...
> > Moderator: jmelson@a... timg@k...
> [Moderator]
> > URL to this page:
> http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> > bill,
> > List Manager
> >
> > FAQ: http://www.ktmarketing.com/faq.html
> >
> > Your use of Yahoo! Groups is subject to
> http://docs.yahoo.com/info/terms/
> >
> >