DC Motors
Posted by
wbhinkle@a...
on 2001-04-23 15:38:37 UTC
I have listed before that i am building the bench top CNC that was presented
in Model Eng Workshop. I think i have found a DC motor for it. It is the same
one that is powering the Grizzly Mini Mill. 110 v at the plug and the motor
takes 90v. The question is what do i have to have to run this motor at 90v ?
bill hinkle
in Oklahoma
in Model Eng Workshop. I think i have found a DC motor for it. It is the same
one that is powering the Grizzly Mini Mill. 110 v at the plug and the motor
takes 90v. The question is what do i have to have to run this motor at 90v ?
bill hinkle
in Oklahoma
Discussion Thread
wbhinkle@a...
2001-04-23 15:38:37 UTC
DC Motors
wanliker@a...
2001-04-23 16:32:06 UTC
Re: [CAD_CAM_EDM_DRO] DC Motors
wanliker@a...
2001-04-23 16:51:32 UTC
Re: [CAD_CAM_EDM_DRO] DC Motors
Rich D.
2001-04-23 16:55:15 UTC
Re: [CAD_CAM_EDM_DRO] DC Motors
Tom Murray
2001-04-23 20:03:09 UTC
Re: DC Motors
ballendo@y...
2001-04-24 03:53:30 UTC
Re: DC Motors
Jason Cox
2003-05-27 04:01:37 UTC
DC Motors
Jon Elson
2003-05-27 10:10:35 UTC
Re: [CAD_CAM_EDM_DRO] DC Motors
Stephan Kotzé
2003-05-27 13:21:05 UTC
RE:DC Motors