Re: Having problems with Lindsay design DRO... Could you please help?

I built the Steve Lindsay DRO a while back, and IIRC I had the same
problems, until I configured the software correctly. I don't remember
the exact configurations but I do know that if you don't have it
configured correctly it will give you errors and not read proper
movements. I will try to look at this tonight, time permitting, and
let you know what I used, or at least what to change.

Steve was very helpful when I did my initial setup.


John Guenther

--- In CAD_CAM_EDM_DRO@y..., mjohnson@h... wrote:
> Hello!
> I have built a DRO using the design provided by Steve Lindsay.
> I have used 360 cpi strips and encoders from US Digital.
> I have done my best to follow the directions provided.
> I did, however, not use the indevidualy shielded wire. I used a 4
> conductor with a single shield around the entire cable.
> It seems to have connectivity, but I get a huge amount of errors. I
> was trying to avoid buying the more expensive wire, but do you think
> this is the problem?
>
> Thanks,
>
> Mike