Deskwin review

Hi everyone,I would like post a short review about the signal
generator and deskwin.
on a pent.166 and windows Me.,28v.switching power supply,Camtronics
2amp,controller and 3 100oz.stepers direct connect to 5mm pitch
ballscrews on Grizzly minimill.

I have not cut parts yet,but it's moving all axis at solid
60ipm,about 2600 sps.
after Cut some parts I'll post a better review.
the best thing is it support a lot more gcodes than desknc for dos.
exept g61 and g28,.

does anybody else have deskwin?.

thank's
Fogassa.