Re: [CAD_CAM_EDM_DRO] Re: RF-45

Alan,
Reno is the closest. So if you were in Sacramento or San Fran it would be a pretty short trip.
San Diego and L.A. is a pretty far drive though.
They don't seem to have anything in the Northwest.

Alan Marconett KM6VV wrote:

> Hi Joe,
>
> No MSC locations in CA, so I guess that's out.
>
> Alan KM6VV
>
> Joe Vicars wrote:
> >
> > MSC has lots of distribution centers. I wonder if you could pick it up yourself at one of their warehouses without having to pay the
> > freight?
> > Anybody know?
> >
> > Alan Marconett KM6VV wrote:
> >
> > > Hi Peter,
> > >
> > > Thanks! I looked it up in MSC, not in stock. And I've been told it's
> > > about $300+ shipping. ENCO's free shipping (well, almost) starts to
> > > look better. Would RongFu be a little better then ENCO? Taiwan vs
> > > China?
> > >
> > > Alan KM6VV
> > > So many mills, so little time (money).
> > >
> > > ptengin@... wrote:
> > > >
> > > > In a message dated 5/14/01 3:39:05 PM Hawaiian Standard Time,
> > > > ronginger@... writes:
> > > >
> > > > << I believe the RongFu 45 is sold by Penn Tool. I have seen other catalogs
> > > > that list some RongFu, but not the 45.
> > > >
> > > > ron ginger >>
> > > > Ron,
> > > >
> > > > I believe MSC has them, there is a look alike at Grizzly too. BTW the
> > > > RF-45 weighs about 700 lbs.
> > > >
> > > > Peter
> > > > THRD, Inc.
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/