Re: [CAD_CAM_EDM_DRO] Re: RF-45

Hi Joe,

Yes, just telling Drew that My wife and I go up to Tahoe and Squaw
valley in the summer. Not that bad a trip from Santa Cruz (central
coast)!

Alan KM6VV

Joe Vicars wrote:

>
> Alan,
> Reno is the closest. So if you were in Sacramento or San Fran it would be a pretty short trip.
> San Diego and L.A. is a pretty far drive though.
> They don't seem to have anything in the Northwest.
>
> Alan Marconett KM6VV wrote:
>
> > Hi Joe,
> >
> > No MSC locations in CA, so I guess that's out.
> >
> > Alan KM6VV
> >
> > Joe Vicars wrote:
> > >
> > > MSC has lots of distribution centers. I wonder if you could pick it up yourself at one of their warehouses without having to pay the
> > > freight?
> > > Anybody know?
> > >
> > > Alan Marconett KM6VV wrote:
> > >
> > > > Hi Peter,
> > > >
> > > > Thanks! I looked it up in MSC, not in stock. And I've been told it's
> > > > about $300+ shipping. ENCO's free shipping (well, almost) starts to
> > > > look better. Would RongFu be a little better then ENCO? Taiwan vs
> > > > China?
> > > >
> > > > Alan KM6VV
> > > > So many mills, so little time (money).
> > > >
> > > > ptengin@... wrote:
> > > > >
> > > > > In a message dated 5/14/01 3:39:05 PM Hawaiian Standard Time,
> > > > > ronginger@... writes:
> > > > >
> > > > > << I believe the RongFu 45 is sold by Penn Tool. I have seen other catalogs
> > > > > that list some RongFu, but not the 45.
> > > > >
> > > > > ron ginger >>
> > > > > Ron,
> > > > >
> > > > > I believe MSC has them, there is a look alike at Grizzly too. BTW the
> > > > > RF-45 weighs about 700 lbs.
> > > > >
> > > > > Peter
> > > > > THRD, Inc.