servo products co. of Pasadena, CA

Is anyone in the group familiar with Servo Products co. of
Pasadena, CA. They make servo cnc mills and retrofit kits ( or
they used to). I was able to aquire a set of 3 motors a pendant,
and driver boards with cnc software. A picture of the motor is
here

http://www.servoproductsco.com/web%20Images/ServoII.gif

They are rated at 165 in-lbs of peak torque and 115 in-lb of
continuous torque. They have a feed rate of 100 ipm and a rapid
feed rat of 190 ipm. They seem very powerfull and weigh about
20 pounds each. I am looking to put them onto my manual mill. If
anyone has had any experience using these motors and
software, I would greatly appreciate hearing from you.

Ed.