Re: [CAD_CAM_EDM_DRO] servo products co. of Pasadena, CA

blueveil@... wrote:

> Is anyone in the group familiar with Servo Products co. of
> Pasadena, CA. They make servo cnc mills and retrofit kits ( or
> they used to). I was able to aquire a set of 3 motors a pendant,
> and driver boards with cnc software. A picture of the motor is
> here
>
> http://www.servoproductsco.com/web%20Images/ServoII.gif
>
> They are rated at 165 in-lbs of peak torque and 115 in-lb of
> continuous torque. They have a feed rate of 100 ipm and a rapid
> feed rat of 190 ipm. They seem very powerfull and weigh about
> 20 pounds each. I am looking to put them onto my manual mill. If
> anyone has had any experience using these motors and
> software, I would greatly appreciate hearing from you.

Do you really have the full system? Does the 'pendant' have the
entire CNC control and servo amps, or is it just the CPU and display,
or just the display?

Without the servo amps and power supply, you may have to buy these,
and hope they are compatible with the control.

Jon