CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Testing the waters...

Posted by Jon Anderson
on 2001-05-18 18:59:39 UTC
Tim Goldstein wrote:

> If Mariss introduces his true servo amplifiers for $99/axis a low cost
> servo board would make for a very compelling package.


I'd just emailed Mariss a couple days ago asking if he had anything like
that in the works, no reply. I assume he's chained to the workbench hard
at work on something. Is this an acutal for real project he is working
on, or just something that he's been discussing?

Jon

Discussion Thread

Tom Kulaga 2001-05-18 18:24:30 UTC Testing the waters... Tim Goldstein 2001-05-18 18:53:50 UTC RE: [CAD_CAM_EDM_DRO] Testing the waters... Jon Anderson 2001-05-18 18:57:35 UTC Re: [CAD_CAM_EDM_DRO] Testing the waters... Jon Anderson 2001-05-18 18:59:39 UTC Re: [CAD_CAM_EDM_DRO] Testing the waters... Tim Goldstein 2001-05-18 19:08:24 UTC RE: [CAD_CAM_EDM_DRO] Testing the waters... mlichty@c... 2001-05-18 19:14:09 UTC Re: Testing the waters... IMService 2001-05-19 04:47:44 UTC Re: Testing the waters... info.host@b... 2001-05-19 07:22:42 UTC Re: [CAD_CAM_EDM_DRO] Testing the waters... ballendo@y... 2001-05-21 20:23:20 UTC Re: Testing the waters... ballendo@y... 2001-05-21 20:26:45 UTC Small tach was Re: Testing the waters... Tom Kulaga 2001-05-23 11:39:13 UTC Re: Testing the waters... Jon Elson 2001-05-23 12:38:21 UTC Re: [CAD_CAM_EDM_DRO] Re: Testing the waters... Eric Keller 2001-05-23 17:02:56 UTC RE: [CAD_CAM_EDM_DRO] Re: Testing the waters... Paul D. Fincato 2001-05-23 18:04:02 UTC RE: [CAD_CAM_EDM_DRO] Re: Testing the waters...