CAD CAM EDM DRO - Yahoo Group Archive

Re: Testing the waters...

Posted by ballendo@y...
on 2001-05-21 20:23:20 UTC
Hi,

Ditto re: the common-ness of four axis setups nowadays...

Ballendo

--- In CAD_CAM_EDM_DRO@y..., "IMService" <imserv@v...> wrote:
> > Date: Fri, 18 May 2001 18:26:50 -0700
> > From: Tom Kulaga <tkulaga@m...>
> >Subject: Testing the waters...
>
> >P.S. I just had a thought: 4 DAC channels means 3
> >servo axes, and a spare signal that could be used to
> >control a VFD. Does that seem more valuable/useful?
> >
>
> Hi Tom, welcome back, it's been a long time.
>
> I would suggest 5 channels so that if somebody wants to also add a
4th axis - rotary, they would also have that option. There are even
a few folks playing with more, but the rotary 4th is now very
affordable and there is no cad-cam software available to program more
than 4 without a sizable mortgage on your home.
>
> Best Regards, Fred Smith- IMService
> Listserve Special discounts and offers are at:
http://209.69.202.197/cadcamedmdro.html
>
> imserv@i... Voice:248-486-3600 or 800-386-1670 Fax: 248-486-3698

Discussion Thread

Tom Kulaga 2001-05-18 18:24:30 UTC Testing the waters... Tim Goldstein 2001-05-18 18:53:50 UTC RE: [CAD_CAM_EDM_DRO] Testing the waters... Jon Anderson 2001-05-18 18:57:35 UTC Re: [CAD_CAM_EDM_DRO] Testing the waters... Jon Anderson 2001-05-18 18:59:39 UTC Re: [CAD_CAM_EDM_DRO] Testing the waters... Tim Goldstein 2001-05-18 19:08:24 UTC RE: [CAD_CAM_EDM_DRO] Testing the waters... mlichty@c... 2001-05-18 19:14:09 UTC Re: Testing the waters... IMService 2001-05-19 04:47:44 UTC Re: Testing the waters... info.host@b... 2001-05-19 07:22:42 UTC Re: [CAD_CAM_EDM_DRO] Testing the waters... ballendo@y... 2001-05-21 20:23:20 UTC Re: Testing the waters... ballendo@y... 2001-05-21 20:26:45 UTC Small tach was Re: Testing the waters... Tom Kulaga 2001-05-23 11:39:13 UTC Re: Testing the waters... Jon Elson 2001-05-23 12:38:21 UTC Re: [CAD_CAM_EDM_DRO] Re: Testing the waters... Eric Keller 2001-05-23 17:02:56 UTC RE: [CAD_CAM_EDM_DRO] Re: Testing the waters... Paul D. Fincato 2001-05-23 18:04:02 UTC RE: [CAD_CAM_EDM_DRO] Re: Testing the waters...