RE: [CAD_CAM_EDM_DRO] Re: Testing the waters...
Posted by
Eric Keller
on 2001-05-23 17:02:56 UTC
I am thinking about buying some motherboards now to save our investment
in ISA data acquisition cards. I just bought 2 new computers, neither
of which have ISA. Current Intel chipsets do not support ISA as far
as I can tell. I think that the firewire, pci, and maybe the parallel
port are the only safe future paths. USB is a little too scary for me.
Eric
-----Original Message-----
From: Jon Elson [mailto:jmelson@...]
Tom Kulaga wrote:
Jon
in ISA data acquisition cards. I just bought 2 new computers, neither
of which have ISA. Current Intel chipsets do not support ISA as far
as I can tell. I think that the firewire, pci, and maybe the parallel
port are the only safe future paths. USB is a little too scary for me.
Eric
-----Original Message-----
From: Jon Elson [mailto:jmelson@...]
Tom Kulaga wrote:
>Oh, certainly DON'T go with ISA, as it is rapidly becoming obsolete!
> Some other thoughts:
>
> Would there be any value to adding either 16 bit bus support (full
> length ISA) or interrupt signals, assuming the I/O chip has interrupt
> outputs? Should I wire a special E-stop disable input to trigger an
> interrupt?
Jon
Discussion Thread
Tom Kulaga
2001-05-18 18:24:30 UTC
Testing the waters...
Tim Goldstein
2001-05-18 18:53:50 UTC
RE: [CAD_CAM_EDM_DRO] Testing the waters...
Jon Anderson
2001-05-18 18:57:35 UTC
Re: [CAD_CAM_EDM_DRO] Testing the waters...
Jon Anderson
2001-05-18 18:59:39 UTC
Re: [CAD_CAM_EDM_DRO] Testing the waters...
Tim Goldstein
2001-05-18 19:08:24 UTC
RE: [CAD_CAM_EDM_DRO] Testing the waters...
mlichty@c...
2001-05-18 19:14:09 UTC
Re: Testing the waters...
IMService
2001-05-19 04:47:44 UTC
Re: Testing the waters...
info.host@b...
2001-05-19 07:22:42 UTC
Re: [CAD_CAM_EDM_DRO] Testing the waters...
ballendo@y...
2001-05-21 20:23:20 UTC
Re: Testing the waters...
ballendo@y...
2001-05-21 20:26:45 UTC
Small tach was Re: Testing the waters...
Tom Kulaga
2001-05-23 11:39:13 UTC
Re: Testing the waters...
Jon Elson
2001-05-23 12:38:21 UTC
Re: [CAD_CAM_EDM_DRO] Re: Testing the waters...
Eric Keller
2001-05-23 17:02:56 UTC
RE: [CAD_CAM_EDM_DRO] Re: Testing the waters...
Paul D. Fincato
2001-05-23 18:04:02 UTC
RE: [CAD_CAM_EDM_DRO] Re: Testing the waters...