CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Testing the waters...

Posted by Jon Elson
on 2001-05-23 12:38:21 UTC
Tom Kulaga wrote:

>
> Some other thoughts:
>
> Would there be any value to adding either 16 bit bus support (full
> length ISA) or interrupt signals, assuming the I/O chip has interrupt
> outputs? Should I wire a special E-stop disable input to trigger an
> interrupt?

Oh, certainly DON'T go with ISA, as it is rapidly becoming obsolete!

Jon

Discussion Thread

Tom Kulaga 2001-05-18 18:24:30 UTC Testing the waters... Tim Goldstein 2001-05-18 18:53:50 UTC RE: [CAD_CAM_EDM_DRO] Testing the waters... Jon Anderson 2001-05-18 18:57:35 UTC Re: [CAD_CAM_EDM_DRO] Testing the waters... Jon Anderson 2001-05-18 18:59:39 UTC Re: [CAD_CAM_EDM_DRO] Testing the waters... Tim Goldstein 2001-05-18 19:08:24 UTC RE: [CAD_CAM_EDM_DRO] Testing the waters... mlichty@c... 2001-05-18 19:14:09 UTC Re: Testing the waters... IMService 2001-05-19 04:47:44 UTC Re: Testing the waters... info.host@b... 2001-05-19 07:22:42 UTC Re: [CAD_CAM_EDM_DRO] Testing the waters... ballendo@y... 2001-05-21 20:23:20 UTC Re: Testing the waters... ballendo@y... 2001-05-21 20:26:45 UTC Small tach was Re: Testing the waters... Tom Kulaga 2001-05-23 11:39:13 UTC Re: Testing the waters... Jon Elson 2001-05-23 12:38:21 UTC Re: [CAD_CAM_EDM_DRO] Re: Testing the waters... Eric Keller 2001-05-23 17:02:56 UTC RE: [CAD_CAM_EDM_DRO] Re: Testing the waters... Paul D. Fincato 2001-05-23 18:04:02 UTC RE: [CAD_CAM_EDM_DRO] Re: Testing the waters...