Re: List of commands for a 1983 vintage Anilam Crusader II milling machine control.

Iain,List,

I hope you will also send the anilam list of codes (and ANY others)
to my yahoo group gcodes. It was started for exactly this type of
use, but has not really been supported. If I can't get people to
post "flavors" of gcode, then it may have to "morph" into a group
about some other aspect of gcodes... I'd be open to hearing
what "other aspect" that might be from list members (offline if it
makes sense to do so)

Thank you in advance.

Ballendo

--- In CAD_CAM_EDM_DRO@y..., hllrsr@c... wrote:
> Somewhere in my filing system I have the G,M, and Canned cycle
codes for all of the Anilam (or should that be ANALam? <gr> Fanuc is
SO much nicer) controllers.
> I'll try to pull them out and send them along.
<snip>
> Iain