Re: [CAD_CAM_EDM_DRO] microkinetics

Hi Chris,

What have your heard/know about FlashCut's going to USB? I'm STILL
interested in their products (even an OLD signal generator)! Just can't
afford 'em!

Alan KM6VV


Chris L wrote:

>
> Doug,
> I really can't say it was too bad inside. The wire layout was simple and
> orderly. The only possible issue was the L.E.D. indicators for I/O. They had
> pigtails on them and the wires ran back accordingly. There wouldn't be much else
> they could do unless they put the LED's on a pc board and ran a ribbon cable.
>
> I ended up redoing a little bit of the original wiring when I added a few Relays
> for output control. I also installed a separate AC Input Plug, whereby all the
> AC powered Items like spindle and dust collection are on a seperate circuit from
> the Drivers.
>
> My only real complaint are the "touchy" acting drivers. I hope to change those
> out to Gecko's. I would purchase a set of 210's right now, but I think I should
> wait until the FlashCut boys release their next version with extended steps per
> second capability via USB communication.
>
> Chris L