emc final questions
Posted by
whollid1@m...
on 2001-07-25 17:41:20 UTC
Now that I have emc up and running I only have 2 glitches left
1: when i try to load in a g-code file I usually fill the first few
lines with the modal codes I.E. g17,g21,g40,etc. However if I try to
load g53 or g10 the program will not run it and instead loads the
default g54 (When I delete g53/g10) which calls out to my var file,
and if I change the var file to 0,0,0 it interprets that as machine
0,0,0 not my part 0,0,0
2: with the bdi install on my 200 pentium, about every other time i
try to do the first jog after starting the system/program I get a
lockup so severe I have to do a power off reboot. Nothing
works...mouse keys.. nothing. Anyone else had this!
1: when i try to load in a g-code file I usually fill the first few
lines with the modal codes I.E. g17,g21,g40,etc. However if I try to
load g53 or g10 the program will not run it and instead loads the
default g54 (When I delete g53/g10) which calls out to my var file,
and if I change the var file to 0,0,0 it interprets that as machine
0,0,0 not my part 0,0,0
2: with the bdi install on my 200 pentium, about every other time i
try to do the first jog after starting the system/program I get a
lockup so severe I have to do a power off reboot. Nothing
works...mouse keys.. nothing. Anyone else had this!
Discussion Thread
whollid1@m...
2001-07-25 17:41:20 UTC
emc final questions
Jon Elson
2001-07-25 23:14:57 UTC
Re: [CAD_CAM_EDM_DRO] emc final questions
Joel Jacobs
2001-07-26 02:18:18 UTC
Re: [CAD_CAM_EDM_DRO] emc final questions
Jon Elson
2001-07-26 10:24:21 UTC
Re: [CAD_CAM_EDM_DRO] emc final questions
Paul
2001-07-26 13:03:05 UTC
Re: [CAD_CAM_EDM_DRO] emc final questions
Paul
2001-07-26 13:03:20 UTC
Re: [CAD_CAM_EDM_DRO] emc final questions
Joel Jacobs
2001-07-26 13:33:10 UTC
Re: [CAD_CAM_EDM_DRO] emc final questions
Ray
2001-07-26 17:13:43 UTC
Re: Re: emc final questions
Ray
2001-07-26 17:13:50 UTC
Re: Re: emc final questions
Joel Jacobs
2001-07-26 22:52:41 UTC
Re: [CAD_CAM_EDM_DRO] Re: Re: emc final questions