CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Re: emc final questions

Posted by Joel Jacobs
on 2001-07-26 22:52:41 UTC
----- Original Message -----
From: Ray <rehenry@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Thursday, July 26, 2001 6:58 PM
Subject: [CAD_CAM_EDM_DRO] Re: Re: emc final questions

> After the NAMES (north american model engineering society) convention,
Joel
> may have switched to the BDI, so that answer is below.
>

Not quite yet! The BDI does not support the on-board graphics controller on
the motherboard in my control (SIS 530). I installed the BDI on another
computer and then plugged the hard drive into my control. I then configured
linux for the on-board video so now I have a working BDI that can run on the
control BUT no netscape, no FTP, no telnet, the ethernet isn't even working
(thats built-in the motherboard too) and the touchscreen doesn't work. So
instead of trying to configure all that stuff again I just temperarily
installed the BDI drive as hdb and mounted it as /BDI.
I'm copying the rcslib emc and rtlinux directories to a whole different
computer with FTP and trying to get the procedure down to install it. When
I get that working I'll do the same on the control itself. It's going to be
at least a week before I'll have time to get back at it.

Joel

Discussion Thread

whollid1@m... 2001-07-25 17:41:20 UTC emc final questions Jon Elson 2001-07-25 23:14:57 UTC Re: [CAD_CAM_EDM_DRO] emc final questions Joel Jacobs 2001-07-26 02:18:18 UTC Re: [CAD_CAM_EDM_DRO] emc final questions Jon Elson 2001-07-26 10:24:21 UTC Re: [CAD_CAM_EDM_DRO] emc final questions Paul 2001-07-26 13:03:05 UTC Re: [CAD_CAM_EDM_DRO] emc final questions Paul 2001-07-26 13:03:20 UTC Re: [CAD_CAM_EDM_DRO] emc final questions Joel Jacobs 2001-07-26 13:33:10 UTC Re: [CAD_CAM_EDM_DRO] emc final questions Ray 2001-07-26 17:13:43 UTC Re: Re: emc final questions Ray 2001-07-26 17:13:50 UTC Re: Re: emc final questions Joel Jacobs 2001-07-26 22:52:41 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: emc final questions