RE: [CAD_CAM_EDM_DRO] EMC Encoders

If you want to use a closed loop stepper system it is designed to use a
Mauch/Kulaga DRO card that is sold by Camtronics or you can get the
plans and wire wrap it from Tom Kulaga's site. You then use smdromod as
the motion controller.

Tim
[Denver, CO]

> -----Original Message-----
>
> Good day all.
>
> I am planning to use EMC to control one of my machines but I
> need to figure out how to hook up the stepper encoders.
>
> Do I need an additional parallel port for the inputs, or do I
> need a special board.
>
> Can anyone point me to some information about using encoders with EMC?
>
> Thanks.
>
> Ethan
>
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>