CAD CAM EDM DRO - Yahoo Group Archive

Re: Tapping Heads

Posted by PTENGIN@x...
on 1999-10-05 02:28:55 UTC
In a message dated 10/04/1999 8:20:04 PM Hawaiian Standard Time,
jmelson@... writes:

<< It tapped 6-32 through holes in .125" Aluminum just beautifully, and in
just a couple seconds each! >>
Jon,
Tell us more in detail as to how it was done. EMC? Manual on a drill
press? What kind of shank does it have? Morse #2? R-8? What RPM did you run?
Alumi Tap? Cutting oil? WD-40? Does it use ER collets?
Thanks.
Peter

Discussion Thread

Jon Elson 1999-10-04 23:27:49 UTC Tapping Heads PTENGIN@x... 1999-10-05 02:28:55 UTC Re: Tapping Heads Marshall Pharoah 1999-10-05 04:16:40 UTC Re: Tapping Heads Bob Bachman 1999-10-05 08:52:28 UTC Re: Tapping Heads Jon Anderson 1999-10-05 07:06:15 UTC Re: Tapping Heads Jon Elson 1999-10-05 12:00:22 UTC Re: Tapping Heads Jon Anderson 1999-10-05 11:57:51 UTC Re: Tapping Heads Paul Corner 1999-10-05 14:15:30 UTC Re: Tapping Heads PTENGIN@x... 1999-10-05 14:55:22 UTC Re: Tapping Heads PTENGIN@x... 1999-10-05 14:59:38 UTC Re: Tapping Heads Jon Elson 1999-10-05 16:20:51 UTC Re: Tapping Heads Dan Mauch 1999-10-05 21:08:21 UTC Re: Tapping Heads TheDragonPit 1999-10-05 21:27:42 UTC Re: Tapping Heads Jon Elson 1999-10-05 21:59:43 UTC Re: Tapping Heads Dan Mauch 1999-10-06 06:09:30 UTC Re: Tapping Heads Jon Elson 1999-10-06 12:44:08 UTC Re: Tapping Heads Dan Mauch 1999-10-06 22:00:13 UTC Re: Tapping Heads PTENGIN@x... 1999-10-07 23:42:15 UTC Re: Tapping Heads