Re: Tapping Heads

I've never measured it at that speed.
Dan
-----Original Message-----
From: Jon Elson <jmelson@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Wednesday, October 06, 1999 12:36 PM
Subject: Re: [CAD_CAM_EDM_DRO] Tapping Heads

>From: Jon Elson <jmelson@...>
>
>
>
>Dan Mauch wrote:
>
>> From: "Dan Mauch" <dmauch@...>
>>
>> I can run my mill drill at 120 IPM with the servo-lite system but speed
>> kills so I have slowed it down to a nice 60 IPM
>
>Just for curiosity, what is the following error at 120 IPM?
>
>Jon
>
>>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems in the above catagories.

>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>For the FAQ, go to http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>