Re: Tapping Heads

Don't gloat. Its not nice. But since you brought it up...
I just bought a South Bend 13" lathe for $310.

Marshall Pharoah
Software Engineer
Adirondac Software
PIC/6805/6811/68000
Asm/C/C++

-----Original Message-----
From: Jon Elson <jmelson@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Tuesday, October 05, 1999 2:20 AM
Subject: [CAD_CAM_EDM_DRO] Tapping Heads

>From: Jon Elson <jmelson@...>
>
>I hope you guys don't mind a gloat.
>
>I got a good deal on a used Procunier 15000 series tapping head.
>I tried it out tonight on a small project - it is VERY neat!
>It tapped 6-32 through holes in .125" Aluminum just beautifully,
>and in just a couple seconds each! This will certainly make an
>upcoming project go a LOT smoother, with about 250 blind
>holes to tap.
>
>Jon
>
>>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems in the above catagories.

>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>For the FAQ, go to http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>