CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] Re: Jumper innovation?

on 2001-09-10 18:54:33 UTC
Peter,
usually the end that the contacts are nearest goes towards the board...

-----Original Message-----
From: cadcamcenter@... [mailto:cadcamcenter@...]
Sent: Monday, 10 September, 2001 9:20 PM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] Re: Jumper innovation?


"Gail & Bryan Harries" <gab@s...> wrote:
> I have on more than one occasion received jumpers that are missing
the
> internal contacts... the plastic shell by itself would fall off???

Dave Rigotti
http://members.aol.com/drigotti/HobbyCNC.htm
asked me to check if the metal is still there, and if I wired it
upside down. It looks like the metal is still there (some yellow
colored wires) and I have the long "poles" pointing heavenward. That
is not upside down isn't it?

Peter


Addresses:
FAQ: http://www.ktmarketing.com/faq.html
FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/

Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
Moderator: jmelson@... timg@... [Moderator]
URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
bill,
List Manager



Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

Discussion Thread

cadcamcenter@y... 2001-09-10 00:56:20 UTC Jumper innovation? Carol & Jerry Jankura 2001-09-10 05:58:37 UTC RE: [CAD_CAM_EDM_DRO] Jumper innovation? Gail & Bryan Harries 2001-09-10 07:35:11 UTC RE: [CAD_CAM_EDM_DRO] Jumper innovation? Alan Marconett KM6VV 2001-09-10 12:10:29 UTC Re: [CAD_CAM_EDM_DRO] Jumper innovation? cadcamcenter@y... 2001-09-10 15:53:08 UTC Re: Jumper innovation? Gail & Bryan Harries 2001-09-10 16:58:27 UTC RE: [CAD_CAM_EDM_DRO] Re: Jumper innovation? cadcamcenter@y... 2001-09-10 18:21:16 UTC Re: Jumper innovation? Gail & Bryan Harries 2001-09-10 18:54:33 UTC RE: [CAD_CAM_EDM_DRO] Re: Jumper innovation? Carol & Jerry Jankura 2001-09-10 19:39:43 UTC RE: [CAD_CAM_EDM_DRO] Re: Jumper innovation? Alan Marconett KM6VV 2001-09-10 22:15:20 UTC Re: Jumper innovation?