Re: Jumper innovation?

Hi Jerry, Peter,

I believe Peter is talking about the G210's (G901 board), which has the
"miniature" header pins and jumpers, not the .025 posts that CAN be
wrapped with a standard WW tool/gun and #30 wire.

My board's jumpers look like a 'U' on the side that goes down on the
board. The top side looks like a single 'I' over to one side (inside
the black housing).

HTH

Alan KM6VV


Carol & Jerry Jankura wrote:

>
> One buys a small "wire wrapping" tool and some kynar #30 gauge wire. It's
> then a matter of stripping about one inch of insulation from each end of the
> wire, placing the stripped end of the wire into a hole in the wire wrapping
> tool, inserting the terminal to be wrapped into the other hole in the tool,
> and spinning the tool. As the tool is spun, the wire is wrapped around the
> post.
>
> It sounds a lot more than the actual process.
>
> As far as your current jumpers, it sure sounds like they're bad jumpers.
> They don't necessarily "click" but should fit tightly onto the posts.
>
> -- Carol & Jerry Jankura
> Strongsville, Ohio
> So many toys, So little time....