CAD CAM EDM DRO - Yahoo Group Archive

Re: Jumper innovation?

on 2001-09-10 15:53:08 UTC
"Carol & Jerry Jankura" <jerry.jankura@s...> wrote:
>
> Are your jumper blocks the standard 0.025 square on 0.1 inch
centers? If so,
> you might want to try wire wrapping the "correct" configuration.
That way,
> it's easy to make a change. Personally, I don't like soldering to
jumper
> blocks because it can be a real pain when you want to reconfigure
them.

How does one wire wrap the configuration?

> Any idea about the CAUSE of them not wanting to stay seated?
Excessive
> vibration, perhaps. There's lots of equipment with jumpers that
functions
> without any problems like you describe. You may want to try to
analyze
> exactly WHY they are unseating themselves and try to fix that
problem.

Haven't finish soldering the board yet. They jus fall off when the
board is manipulated - there is no "click" feeling when they are
press on, so it must be from a lack of friction/tightness.

Thanks for responding

Peter
:

Discussion Thread

cadcamcenter@y... 2001-09-10 00:56:20 UTC Jumper innovation? Carol & Jerry Jankura 2001-09-10 05:58:37 UTC RE: [CAD_CAM_EDM_DRO] Jumper innovation? Gail & Bryan Harries 2001-09-10 07:35:11 UTC RE: [CAD_CAM_EDM_DRO] Jumper innovation? Alan Marconett KM6VV 2001-09-10 12:10:29 UTC Re: [CAD_CAM_EDM_DRO] Jumper innovation? cadcamcenter@y... 2001-09-10 15:53:08 UTC Re: Jumper innovation? Gail & Bryan Harries 2001-09-10 16:58:27 UTC RE: [CAD_CAM_EDM_DRO] Re: Jumper innovation? cadcamcenter@y... 2001-09-10 18:21:16 UTC Re: Jumper innovation? Gail & Bryan Harries 2001-09-10 18:54:33 UTC RE: [CAD_CAM_EDM_DRO] Re: Jumper innovation? Carol & Jerry Jankura 2001-09-10 19:39:43 UTC RE: [CAD_CAM_EDM_DRO] Re: Jumper innovation? Alan Marconett KM6VV 2001-09-10 22:15:20 UTC Re: Jumper innovation?