Re: Stepper size?

It was free to download and use, not even a copyright notice.

It's about 700k zipped. Can upload it but isn't "files" full.

Or can E-mail it.

--- In CAD_CAM_EDM_DRO@y..., dlantz@a... wrote:
> is it a freeware programs? can you share it with us? that would be
> great!---Dave L.
>
> -----Original Message-----
> From: shymu@b... [mailto:shymu@b...]
> Sent: Thursday, September 27, 2001 6:27 AM
> To: CAD_CAM_EDM_DRO@y...
> Subject: [CAD_CAM_EDM_DRO] Re: Stepper size?
>
>
> I have a program that calculates servo/stepper size based on load,
> ramp speed, screw pitch/type, slide type, etc. And outputs are data
> and graphs showing torque needed. Data entry is easy with great help
> files. Very usefull !
>
>
>
> --- In CAD_CAM_EDM_DRO@y..., zbadone@b... wrote:
> > I am in the process of designing my XYZ table. I am interested in
> > routing machinable wax for use with my casting furnace, light wood
> > routing and perhaps (light) engraving aluminum. Not very deep cuts
> in
> > the aluminum.
> >
> > I am trying to figure out a decent size stepper motor to use. I
came
> > accross a few on the net in the 125 oz/in model, one is a Size 23
> > ($40)Vexta PK226-02A, 200 s/r 3.6v@2A
> > and the other is a Size 34 ($25 used)125oz 2.5v@2... 200 s/r(steps
> per
> > rev).
> >
> > My table is what will be moving, made out of 3/4" cabinet grade
ply,
> > 24" * 30". What would be the recommended size based on my
> application?
> >
> > The over head gantry will house a Dewalt 1/4" laminat trimmer, not
> > much weight.
> >
> > Anybody have an opinion on these types of stepper or do you have
> > another source I could look at?
> >
> > Thanks.
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@y...
> Subscribe: CAD_CAM_EDM_DRO-subscribe@y...
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@y...
> List owner: CAD_CAM_EDM_DRO-owner@y..., wanliker@a...
> Moderator: jmelson@a... timg@k... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/