Re: [CAD_CAM_EDM_DRO] Taig Software was Re: PCMIA Card and SS Software

Ballendo, thanks for the info, but I'm afraid it won't help me. I found I
could not see the menus well enough on SuperCAM and my laptop. Tiny words
in fuzzy yellow is how my laptop presented them. So I went to BobCad-Cam,
with which I am very pleased, by the way. The G-codes are presented to the
machine through MPS-2000, which is also a part of the Taig package.

Dave Goodfellow
Northridge, CA
"No problem too small to baffle this expert"

----- Original Message -----
From: <ballendo@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Tuesday, November 06, 2001 5:05 PM
Subject: [CAD_CAM_EDM_DRO] Taig Software was Re: PCMIA Card and SS Software


> Alan,Dave,
>
> The Taig software has been SuperCAM in the past. Prob'ly still is...
> Dennis Bohlke (who wrote supercam) programmed into the controller the
> ability to use pinouts comaptible with both phase and step/dir
> drivers. So if the port is the issue, you may be able to get around it
> by using s/d drives and changing the config in the SuperCAM s/w setup.
>
> Hope this helps.
>
> Ballendo
>
>
> --- In CAD_CAM_EDM_DRO@y..., Alan Marconett KM6VV <KM6VV@a...> wrote:
> > Hi Dave,
> >
> > Sounds like the Taig might be 4-phase drive (unipolar). Takes a few
> > more pins! <snip>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>