CAD CAM EDM DRO - Yahoo Group Archive

Re: Calculations for XL 037 pullies and cutters

Posted by phrh@w...
on 2001-11-26 15:18:12 UTC
--- In CAD_CAM_EDM_DRO@y..., machines@n... wrote:
> The XL range of pullies all have a pitch of 0.200"
> The included angle of the cutter is 50 degrees and the width of the
> cutter at the tip is 0.052"
>
> Outside diameter is found by subtracting a constant K from the PCD.
> Same example again:-
> 1.910 - 0.020 = 1.890" dia
> The constant K is 0.020 for the whole of the XL range.
>
> Last piece of information needed is the depth of the cutter infeed.
> Again this is constant throughout the XL range at 0.065" deep.

Thanks for the information. The "K" has been the problem for me. Do
you know how it is derived? Richard

Discussion Thread

machines@n... 2001-11-26 13:06:25 UTC Calculations for XL 037 pullies and cutters Alan Marconett KM6VV 2001-11-26 14:44:17 UTC Re: [CAD_CAM_EDM_DRO] Calculations for XL 037 pullies and cutters machines@n... 2001-11-26 15:04:16 UTC Re: Calculations for XL 037 pullies and cutters phrh@w... 2001-11-26 15:18:12 UTC Re: Calculations for XL 037 pullies and cutters Chris Clough 2001-11-26 15:29:27 UTC Plasma control Darrell Daniels 2001-11-26 17:30:26 UTC Re: [CAD_CAM_EDM_DRO] Plasma control Alan Marconett KM6VV 2001-11-26 18:50:37 UTC Re: [CAD_CAM_EDM_DRO] Calculations for XL 037 pullies and cutters Steve Smith 2001-11-26 20:50:16 UTC Re: [CAD_CAM_EDM_DRO] Plasma control Chris Clough 2001-11-26 21:30:15 UTC Plasma Cutting Software? cncdxf@a... 2001-11-27 08:15:42 UTC Re: Plasma Cutting Software? Chris Clough 2001-11-27 08:19:01 UTC RE: [CAD_CAM_EDM_DRO] Re: Plasma Cutting Software? roundrocktom@y... 2001-11-27 09:15:24 UTC Re: Plasma control Carol & Jerry Jankura 2001-11-27 14:04:00 UTC RE: [CAD_CAM_EDM_DRO] Plasma Cutting Software?