CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] Re: tach output

Posted by Tim
on 2001-12-20 13:35:48 UTC
From what Mariss (The Gecko King) has posted, no the drives will not
function correctly with linear encoders. The concern is that the encoder
will not be coupled to the encoder tightly enough and the servo loop
will not be stable. It may work in some cases if you have a VERY tight
setup with virtually no backlash, but that is not what you are
describing.

Tim
[Denver, CO]

> -----Original Message-----
>
> Is it possible to use a linear encoder of some sort to
> provide the feedback to the Gecko driver in place of a rotary
> encoder on the servo motor shaft? I realise that this would
> still not provide position feedback to the CPU but it might
> provide some compensation for backlash in the lead screw.
>
> Regards,
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/

>
>

Discussion Thread

jakefife 2001-12-17 16:40:34 UTC tach output Tim 2001-12-17 16:50:24 UTC RE: [CAD_CAM_EDM_DRO] tach output ccs@m... 2001-12-17 16:58:40 UTC Re: [CAD_CAM_EDM_DRO] tach output Jon Elson 2001-12-17 22:53:13 UTC Re: [CAD_CAM_EDM_DRO] tach output jakefife 2001-12-18 17:38:16 UTC Re: tach output Jon Elson 2001-12-18 22:58:37 UTC Re: [CAD_CAM_EDM_DRO] Re: tach output Ray 2001-12-19 07:16:52 UTC Re: Re: tach output jakefife 2001-12-19 19:15:21 UTC Re: tach output Thanks for the help David Micklethwaite 2001-12-20 13:14:23 UTC Re: [CAD_CAM_EDM_DRO] Re: tach output Tim 2001-12-20 13:35:48 UTC RE: [CAD_CAM_EDM_DRO] Re: tach output mariss92705 2001-12-20 13:57:37 UTC Re: tach output Jon Elson 2001-12-20 22:57:01 UTC Re: [CAD_CAM_EDM_DRO] Re: tach output Jon Elson 2001-12-20 23:11:34 UTC Re: [CAD_CAM_EDM_DRO] Re: tach output mariss92705 2001-12-20 23:27:02 UTC Re: tach output rainnea 2001-12-21 03:34:31 UTC Re: tach output Tim Goldstein 2001-12-21 07:09:02 UTC Re: [CAD_CAM_EDM_DRO] Re: tach output Paul 2001-12-21 13:22:34 UTC Re: [CAD_CAM_EDM_DRO] Re: tach output rainnea 2001-12-21 17:01:44 UTC Re: tach output Jon Elson 2001-12-21 23:24:12 UTC Re: [CAD_CAM_EDM_DRO] Re: tach output Jon Elson 2001-12-21 23:32:37 UTC Re: [CAD_CAM_EDM_DRO] Re: tach output